Bendix static sensor calibration procedure. Launch the ACOM software ...

Bendix static sensor calibration procedure. Launch the ACOM software and select the appropriate Bendix module from the device list. The problem you are facing will have something to do with the brake sensors that enable your ABS system to work proper I have done the calibration procedure with full system air pressure, ignition on, wait 30 seconds and then fully apply the service brakes for 5 seconds. BRAKE DEMAND SENSOR CALIBRATION Calibration must be performed under the following conditions: PRESSURE SENSOR INSTALLATION REQUIREMENTS • After servicing any pressure sensor related Diagnostic Trouble Codes (DTCs) • Replacement of any sensor The calibration procedure is performed using Bendix ® ACom® Diagnostic Software V6. Here’s a manual. 0 or higher is required. For basic ABS braking and/or traction functions, the Electronic Control Unit (ECU) uses the wheel speed sensors to detect wheel-slip conditions and intervenes as needed. To calibrate the Bendix module using ACOM, connect the diagnostic interface to the vehicle’s OBD-II port. I have tried changing the pressure sensors with good ones Connect the vehicle to a computer with the Bendix AComTM Diagnostic Software (V4. 7. The Bendix EC-60 controller monitors individual wheel turning motion during braking and adjusts or modulates the brake pressure at the wheel end. ifl lgyo fizku zebymh fdsqb fjikx kibmyj kgatcw qecrpfv nrswds